ok so a couple days ago I took the Judge to get the exhaust done at a shop close to John's house... when i picked it up I noticed that the cut out was WAY too low. I asked him to fix it but he said he was too busy and I could bring it back this week.
Well I didn't want to take off work to do it and he doesn't work late. so Sam took it to OrangeChevyII today.. MAN.. I should have gone to him first! he cut off everything that the other guy put on because it just wasn't good enough. so here are a couple pics of the exhaust before and after
BEFORE
notice the cut out is pointed forward and to the side (scooping air into the exhaust)
AFTER
now here is what OrangeChevyII put together for me... I haven't seen it in person yet.. but I'm SUPER happy with what I see! thanks again man
and I hope your happy that you got to cut out those flowmaster copies haha
before the cut out and tail pipes where built
with the cut out
tailpipes
ignore the rust ass looking rear end
Well I didn't want to take off work to do it and he doesn't work late. so Sam took it to OrangeChevyII today.. MAN.. I should have gone to him first! he cut off everything that the other guy put on because it just wasn't good enough. so here are a couple pics of the exhaust before and after
BEFORE
notice the cut out is pointed forward and to the side (scooping air into the exhaust)
AFTER
now here is what OrangeChevyII put together for me... I haven't seen it in person yet.. but I'm SUPER happy with what I see! thanks again man
and I hope your happy that you got to cut out those flowmaster copies haha
before the cut out and tail pipes where built
with the cut out
tailpipes
ignore the rust ass looking rear end
Comment