ok so i am looking to do a little more to my mach one mustang here is a list of the mods as of now what do you guys suggest
Built motor (Built at 60,000 Miles)
Manley H-Beam Rods
JE 10cc Pistons
Valve Job on Heads
Bored .020
Powdercoated Valve Covers
42LB Injectors
2003 Cobra MAF
Eaton Swap
Custom Pulley Bridge
2.93 BilletFlow Pulley/Hub Combo
LFP 4# Lower Kit
Roush Tensioner
LFP Upgraded Heat Exchanger
Transmission
Rebuilt at 50,000(third gear synchro went out so entire transmission was rebuilt)
Centerforce Dual Friction Clutch 3k Miles
MGW Short Throw Shifter
Exhaust
UPR O/R X
Polished MagnaFlow Catback
I was thinking cams and and a posi locker but not sure what i will get the best results from
Built motor (Built at 60,000 Miles)
Manley H-Beam Rods
JE 10cc Pistons
Valve Job on Heads
Bored .020
Powdercoated Valve Covers
42LB Injectors
2003 Cobra MAF
Eaton Swap
Custom Pulley Bridge
2.93 BilletFlow Pulley/Hub Combo
LFP 4# Lower Kit
Roush Tensioner
LFP Upgraded Heat Exchanger
Transmission
Rebuilt at 50,000(third gear synchro went out so entire transmission was rebuilt)
Centerforce Dual Friction Clutch 3k Miles
MGW Short Throw Shifter
Exhaust
UPR O/R X
Polished MagnaFlow Catback
I was thinking cams and and a posi locker but not sure what i will get the best results from
Comment