I figured I would share this exhaust I made for a buddies car . I thought it might help out anybody using the cheap Summit/Flowtech long tubes that they don't make an X or H pipe for . The driver side header collector is about 5" out of line with the hump in the tranny cross member so I had to make a bend . I used all Summit parts including the 3" 3 bolt collectors , 3" universal X pipe , 3" Summit 2 chamber mufflers , 3" 180* mandrel U bend and an extra 3" x 4' straight pipe . I have run into these headers a few times so I know people are using them . I got it to tuck up real tight and it doesn't hang any lower then a frame connector . Please pardon the welds . Most are but joint and I use a wire feed with no gas so they aren't quite as pretty as allot that I see on the board . BTW , this is an 83 capri that is a total low budget toy saved from the crusher and has a HCI 306 with a 5 speed .
Announcement
Collapse
No announcement yet.
Poor Man's 3" fox Exhaust
Collapse
X
-
Looks good!Interested in being a VIP member and donating to the site? Click here http://dfwmustangs.net/forums/payments.php
Comment
-
for Texas inspection sticker
The exhaust must exit the body. I had a buddy die from Co in the winter while driving because his exhaust exited under the car. It was long ago in oak cliff,Don't worry about what you can't change.
Do the best you can with what you have.
Be honest, even if it hurts.
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy; Its inherent virtue is the equal sharing of misery" ... Winston Churchill
Comment
-
Originally posted by jyro View PostThe exhaust must exit the body. I had a buddy die from Co in the winter while driving because his exhaust exited under the car. It was long ago in oak cliff,"It's another burrito, it's a cold Lone Star in my hand!"
Comment
Comment