HCI 306 dyno sheet

[Damnittsteve]

too much to last.

[Txstang1]

I ran 6.70s for years with Y heads, stockish short block and a 150 shot

[G..]

How would this combo improve with a set of afr 165's? That's what head I have and would love that torque,

It would make over 300 with decent heads. But make more power with old twisted wedges than the 165's.

[Turbosvo]

How much difference is there between a dyno jet and mustang dyno? My hci car only put down 253hp/265torque on a mustang dyno :-(

[juicedgt]

I figure it'll do 7.50's

I ran 6.70s for years with Y heads, stockish short block and a 150 shot

[juicedgt]

352hp 510trq at 12lbs. We ran outta maf at 3500. Parts are on order for the retune

[Sean88gt]

Nice tq

[46Tbird]

You might want to cut that boost back a little. Out of MAF at 3500rpm and already at 510 tq? Its gonna be strong while it lasts.

[robert]

Here's another 306 dyno results Carb style

http://www.southeasternfoxbodies.com/forums/showthread.php?t=35028

[Doug Hatton]

My car made 420 with stock heads and intake at 12lbs. 500 at the same boost level with baby edelbrocks. 550 with open exhaust.

[Sean88gt]

^for how long?

[juicedgt]

I'm only planning to run 8-10lbs. I had the 8lb spring in it and on the first pull it hit 18lbs!!! I have a turbosmart boost T and during the pulls it was turned all the way down.

You might want to cut that boost back a little. Out of MAF at 3500rpm and already at 510 tq? Its gonna be strong while it lasts.

[Sleeper]

are you going to get some sort of electronic controller?

[juicedgt]

I wasn't planning in it. Will the manual turbosmart I'm currently running not work?

are you going to get some sort of electronic controller?

[Sleeper]

Itll work fine, there is just more control with electronic units. Plus im happy if i have more buttons to push and shit.