what to expect

[Cobra2010]

I am putting together an almost identical setup, except i am carb'd and only have 3:73 gears.

[Diabolic]

What's the compression ratio? Intake is an RPM, RPM II? TB is 65, 70, 75mm? I would guess 325 RWHP as long as the compression is above 9.1 and the tune is good. I would go with a 90mm LMAF meter.

[TENGRAM]

So, are you say the tq and hp will be equal at 5252 rpm

As long as your using HP, RPM, and lb-ft units... Always!

[mustangguy289]

about 3ish

[dumpycapri85]

you 2 should fuck and get it over with.

Steves talking to his tits again .

[Cobra2010]

What's the compression ratio? Intake is an RPM, RPM II? TB is 65, 70, 75mm? I would guess 325 RWHP as long as the compression is above 9.1 and the tune is good. I would go with a 90mm LMAF meter.

My combo has a torquer II intake and a little over 10:1 comp.

[80coupe]

Steves talking to his tits again .

or his left and right hand!

[Damnittsteve]

or his left and right hand!

u would know

[80coupe]

u would know

douche! ha!

[TENGRAM]

What's the compression ratio? Intake is an RPM, RPM II? TB is 65, 70, 75mm?

I took into account the fact that he didn't feel that info was important... reason my estimate is so low.