Shift Solenoids PA Full Manual Valvebody

[Rough Customer]

http://ww2.justanswer.com/uploads/babarche/2008-09-19_231808_Performance_Automatics_AODE_valve_body_pa45302.pdf

To activate overdrive I apply power to SS1 and SS2 at the same time, yes? What do I do with SS VPWR?

To activate converter lockout, I ground TCC and apply power to TCC VPWR?

Thanks,
J

[CatDaddy]

The way I read it is to connect SS1, SS2 and TCC all to a ground source. Then connect VPWR and VPWRTCC to a switch to supply 12V when you want to use overdrive and converter lockup. It recommends that you use them together.

[greenbullitt]

what are you trying to do?

[Rough Customer]

what are you trying to do?

Overdrive and converter lockup.

What Cat D said makes sense. I'm probably just reading the directions wrong.

[greenbullitt]

Overdrive and converter lockup.

What Cat D said makes sense. I'm probably just reading the directions wrong.

I would not lock the convertor at the same time, I would lock it after the od shift imo

[Rough Customer]

I would not lock the convertor at the same time, I would lock it after the od shift imo

Yeah I already set up the switch panel in the ash tray location I just have to figure out what to power and what to ground. I have one switch for OD, one switch for Lockup and one switch that ties the two together on the first switch. I might end up setting up a 2 second timer so that one switch will activate overdrive and then 2 seconds later lock the converter. Like you, I do not like the idea of shifting and locking up at the same time. It just doesn't seem like good practice.

J