Announcement

Collapse
No announcement yet.

Rear Control arms??

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Originally posted by BlueCoupeRedVert View Post
    Are you using the baseline Pro-Launch kit or just the arms? Looks like some nice stuff.
    You know what, I'm not sure. I bought them used and hadnt compared what I have to their website. I''ll check

    Comment


    • #17
      The baseline pro launch upper set up is what I'm seriously considering, I'm looking for a nice lower arm, the baseline lower looks like it might get the vote.

      I'm also considering coil overs, but don't fully understand them.

      My coupe will launch hard. That's all I want.

      320rwhp. 7.67 @ 90mph 1.7 60'

      DD: 2004 GMC Sierra VHO 6.0 LQ9 324whp 350wtrq

      Comment


      • #18
        You might also want to look into Team Z's rear suspension kit. Very similar to the Baseline. If your going with coilovers you can get the offset lower without the spring perch so later down the road when/if you minitub the car you wont have to make any rear suspension changes... It's already there.
        Dont forget the antiroll bar... Can always just unhook when not in use.

        Comment


        • #19
          Mine are made by Factory Five and were on the car when I bought it. I haven't seen the need to replace them just yet....

          Comment


          • #20
            I like Team Z, Dave is the man and his relocated uppers are badass! I guess it depends on your plans with the car, I had cheapy granatelli wheight jackers and switched to team-z, night and day difference. I could hook first on the street in a mid 550hp turbo lx on 275 dr's.
            Ded

            Comment


            • #21
              thanks guys. a lot of good info on parts/companies I did know about!
              Doug

              90 LX Coupe 5.0
              90 7up Vert. 5.0

              Comment


              • #22
                I had good luck and zero problems with Hotchkis.

                Comment


                • #23
                  I have the MM XD adjustable. I got them as part of my TA/PHB package. Build quality is amazing on them. I held them next to some UPR, and the difference really shows. I am not downing UPR either. MM is just quality.

                  Others I have yet to try, but have some friends that own are J&M and Team Z. Both have been real nice for my friends, but I personally have never had them.

                  Comment


                  • #24
                    FMS uppers and M&M XD lowers..... not bad for daily use...(trq boxes welded for sure.)

                    I plan on swapping over to baseline stuff though....

                    THe above setup hooked (on slicks) but not consistantly....
                    I did pull the left front tire launching a 4 pot..

                    Comment


                    • #25
                      Originally posted by Mustangman_2000 View Post
                      I had good luck and zero problems with Hotchkis.
                      Same here.

                      Comment

                      Working...
                      X