Anyway to figure out the door code for a newly bought 2011 Expedition?
Announcement
Collapse
No announcement yet.
Door pass code for 2011 Expedition
Collapse
X
-
A couple of forums say to look on the fusebox behind the passenger side kick wall panel.
Displaying the Factory Set Code
With Integrated Keyhead Transmitters
You will need to have two programmed passive anti-theft keys for this procedure. To display the factory-set code in the information display:
Insert a key into the ignition and switch the ignition on for a few seconds.
Switch the ignition off and remove the key.
Insert the second key into the ignition and switch the ignition on.
The factory-set code will display for a few seconds. It may not display until after other warning messages have displayed first.
With Intelligent Access Keys
You will need to have two programmed intelligent access keys for this procedure. To display the factory-set code in the information display:
Place the first programmed key in the backup slot inside the center console. The key ring must be at the top with the buttons facing toward the rear. If there is no backup slot, place the key underneath the rubber covering at the bottom of the cup holder.
Press the START/STOP button once and wait a few seconds.
Press the START/STOP button again and remove the key.
Insert the second programmed key into the backup slot, then press the START/STOP button.
The factory-set code will appear in the information display for a few seconds. It may not display until after other warning messages have displayed first.
Comment