ls1 crank pulley installer

[black90notch]

Whet can I find the all thread for the ls1 crank? Im trying to make my own tool. Or does someone have the tool I can borrow?

[Lone Star Performance]

You can just use a longer bolt to pull the balancer up, or place a 2x4 flat across the balancer and carefully hammer it far enough on where your crank bolt will thread in and pull it up.

[JC316]

You can just use a longer bolt to pull the balancer up, or place a 2x4 flat across the balancer and carefully hammer it far enough on where your crank bolt will thread in and pull it up.

That's how I do it too. GM made both the Gen II and Gen III motors a pain to install the HB.

[black90notch]

I'll try the 2x4 method. I had heard of it but was hesitant.
I'm just ready to get this car going.

[Lone Star Performance]

It isn't too bad to do it with a 2x4

[NoClassic]

The bolt is m16 x 2.0

I found one at Turner hardware a while back that works.