Wire tucking engine harness on a fox.

[91CoupeMike]

Then do it. I have 2 connectors with a total of 62 pins. More than enough pins for efi that you run.

Best place to buy them?

I would also like something like that but hollow so I can run my nitrous plumbing through the fire wall without using a cheap assed grommet.

[bonnie&clyde]

so what was the outcome?

[Z06killinsbf]

so what was the outcome?

A Banshee got built and destroyed

[91CoupeMike]

In the process of pulling the dash to put the harness behind it, and yes a banshee was built and blown up and I did a c notch and dropped my truck more. And bought a 351 and a turbo.

Haha!

[bonnie&clyde]

Any update on this?? Did u end up running the wires behind the dash??? Seemed like more work than trying to get it under the pinchweld, I'm in the process of doing mime

[91CoupeMike]

Yeah I have the tuck done. After going through all the work to get the harness behind the dash, I came to the drivers side and realized it was going to be too much work then I had originally planned. Having to pull everything on the drivers side under hood inside the car and back out again. I ended up just putting everything behind the fenders and going to run it along the pinch weld. Doing what I wanted would have been a pain in the ass without completely pulling the harness out, trimming it up and re looming it. If I were to do this then I would have had to repin all of the connectors to allow the flex sleeve stuff to slide on.

I may eventually do something like this. As well as bulkhead connectors vs just running shit through a hole. Time isn't on my side at the moment, I'm trying to finish this car so I can move out of my apartment. Lol plus my girlfriends car turned into a pos so I bought a 04 rcsb Chevy so she has something to drive... Anyone know of a 6.2 core motor or maybe a gto t56?

It's in the mock up process now so it's constantly evolving as I make progress. All the sound deadbeat installed needs to come out because I went full tard and did it before the through the floor subframe and cage.. Haha

Passenger side:


Drivers:


Firewall: need the Scott rod plates welded or bonded somehow. Also doing a manual brake conver$ion.


Fun stuff


Three honk mod.



Baer t4 13 inch brake upgrade.

[91CoupeMike]

Still need to weld the Scott rod plates on.

[bonnie&clyde]

Looks good, im about 90% done with mine, it was alot more work than I thought

[bonnie&clyde]

where are you gonna put your ignition coil?