Picking pistons

[MR EDD]

Need help picking piston

281 4.6 liter 2 valve

cam spec:
Motor list is defined as:

Part no. 102-501-9l
01 intake master 9266
02 exhaust master 9267
03 engine ford 4.6l & 5.4l sohc modular (1992-)
04 grind number xe262ah-13
05 part no descri
06 hydraulic y/n yes

intake exhaust
07 valve adjustment hyd .hyd
08 max gross valve lift .545 .545
09 cam lobe lift .3000 .3000
10 adv dur @ .006 261 265
valve lift
11 dur @.050 valve lift 226 230
12 valve timing @ opening closing
.050 valve lift 4 btdc 42 abdc
52 bbdc 2- atdc

trickflow heads 44 c.c.
Manley rods
vortech v-2 supercharger w/ watercooled aftercooler

had 23 c.c. Pistons

would like to run a double Power adder.

One being supercharger with a wet kit or dry kit. Not sure which one yet.but not sure how to pick piston. I know dished pistons but how much dish is needed to prevent piston melt down.

[Cooter]

I'd run a triple power adder

[KungFuHamster]

id say keep the 23cc piston since the trick flow combustion chamber lowers the CR slightly. just make sure you have plenty of fuel system and a good plug

I'd run a triple power adder

and this

[93bluelx]

I'd run a triple power adder

i swear. you are just a prick. fuck w people in the back porch. so he didnt word his question in a manner that is suitable to you. so what.

mr edd, who is building your motor? did they suggest anything to you

[94mstng94]

LOL @ who is building motor...

[Hay Burner]

Which shop in Houston are you going to use?

[93bluelx]

LOL @ who is building motor...

assembling?

[93bluelx]

LOL @ who is building motor...

putting together?

[fordracing19]

lol

[jw33]

i swear. you are just a prick. fuck w people in the back porch. so he didnt word his question in a manner that is suitable to you. so what.

mr edd, who is building your motor? did they suggest anything to you

I LOL'd x3

[90GT50]

I don't know which is worse, lol.

[Rotortrash]

assembling?

putting together?

It's not your grammar he's LOLing at there Cheif.

[93bluelx]

It's not your grammar he's LOLing at there Cheif.

lol. i dont get it then. what the fuck is a cheif anyway?

[stevo]

This will only get better with the new cheerleader.

Stevo

[MR EDD]

Is there a way to firure how much compression is best to make sure i get the desire comression for the design.i dont want to run 14:1 say design or optium is 10:1. How do i find this information based on what the parts will produce. Say the parts list produce's 13:1 when design is 12:1.