Tweet
I've read, and watched a few videos.... But have questions.
Working on checking pushrod length now:
1. I laid the heads on with the gasket... How tight to I bolt them down to check pushrod length? Surely not full torque? Wouldn't that waste my pt9333?
2. While I feel like the rocker is centered, I feel like it's a little heavy on the right side of the valve guide. I don't see much of a mark on the left side.
3. Once I have the right length pushrods, I can move to PTV... Again, how tight do I bolts the heads down? Am I supposed to go to full torque?
4. I plan on using play-dough to check PTV... I'm confident I have enough clearance, but I've read that the radial clearance in the reliefs may be a concern. How do I check that?
I will have more questions when I get to this point so stay tuned!
Sent from my iPhone using Tapatalk
Working on checking pushrod length now:
1. I laid the heads on with the gasket... How tight to I bolt them down to check pushrod length? Surely not full torque? Wouldn't that waste my pt9333?
2. While I feel like the rocker is centered, I feel like it's a little heavy on the right side of the valve guide. I don't see much of a mark on the left side.
3. Once I have the right length pushrods, I can move to PTV... Again, how tight do I bolts the heads down? Am I supposed to go to full torque?
4. I plan on using play-dough to check PTV... I'm confident I have enough clearance, but I've read that the radial clearance in the reliefs may be a concern. How do I check that?
I will have more questions when I get to this point so stay tuned!
Sent from my iPhone using Tapatalk