Tweet
So there is a know problem with leaking 94-95 5.0 fuels lines ( hard nylon lined ones from firewall to fuel rail) I was doing the mod to replace these lines with Russel 6AN EFI push on fittings with braided steel lines. To my screw up I put a pin hole in the 5/16th hard line that comes up the inner fender(chassis fuel line).
My options I know of 1. Cut and flare hard line and run 5/16 to 6AN
2. Use compression fitting 5/16 to 6AN
3. 37 degree flare with tube and tube nut to 6AN
I can't get any clear answer on if any of these steps would hold up to EFI fuel pressures. Or is there a better way anyone knows of. Any help would be appreciated.
My options I know of 1. Cut and flare hard line and run 5/16 to 6AN
2. Use compression fitting 5/16 to 6AN
3. 37 degree flare with tube and tube nut to 6AN
I can't get any clear answer on if any of these steps would hold up to EFI fuel pressures. Or is there a better way anyone knows of. Any help would be appreciated.
Comment