Anyone work at a Ford Parts House?

[Doug Hatton]

I need to see if someone can give me some information about an A/C line on a 2012 GT. It's the line identified in Box #20 on the link below.

http://www.tascaparts.com/parts/2011/FORD/MUSTANG/GT/?siteid=213668&vehicleid=1446394&diagram=JC10147

I need to know if the part that looks like it's insulated is AC Hose right there, or if that's just insulation over the hard line. This is buried in the front passenger side of the car, and I can't get a good look at it. Hoping someone can put their hands on one. Thanks in advance!

[Doug Hatton]

No one?

[BradM]

I think a dude screen named coley on here does. You might send him a pm.

[Doug Hatton]

Thanks. I sent him a PM.

[351Coupe]

Coley and Lee Early

[ELVIS]

Coley and Lee Early

yeah. i think they are in mckinney or sherman or something. both cool dudes

god bless.

[NoClassic]

Just went and looked at my Dads and its a rubber hose underneath the foam jacket.

[Rick Modena]

Call me or send me a text Doug, I have two hook-ups.

[Doug Hatton]

I think it is too, but I haven't pulled the insulation back enough to confirm it. PLUS, it's a bitch to even get to it! Henry, I'm not looking to buy one. I'm actually looking at installing a Killer Chiller on my car to cool the intercooler fluid for the a/w intercooler. (borrowing from the '03 Cobra world!) I need to be able to tap into the liquid and suction sides and the kit is designed to splice into a section of hose.

Just went and looked at my Dads and its a rubber hose underneath the foam jacket.

[351Coupe]

yeah. i think they are in mckinney or sherman or something. both cool dudes

god bless.

Blake Utter in Denison. They've always been helpful to me.

[NoClassic]

I think it is too, but I haven't pulled the insulation back enough to confirm it. PLUS, it's a bitch to even get to it! Henry, I'm not looking to buy one. I'm actually looking at installing a Killer Chiller on my car to cool the intercooler fluid for the a/w intercooler. (borrowing from the '03 Cobra world!) I need to be able to tap into the liquid and suction sides and the kit is designed to splice into a section of hose.

I can without a doubt say its a rubber hose. I was able to push the foam down a few inches to see the crimp fitting and then hose.

[Doug Hatton]

Badass. That's what I was looking for. Thanks! That's the only piece of hose on that single line and where I'll have to tap into it.

I can without a doubt say its a rubber hose. I was able to push the foam down a few inches to see the crimp fitting and then hose.

[NoClassic]

No problem. I have always been interested in those chiller systems. Be sure to log some intake temp data before and after if you can.