May need a machine shop near Denton

[Veight7]

So I was going to install the heads in my new motor flipped em over and this is what I saw.

You can't feel it but it's clearly there. Should I bother having it machined off if it's so miniscule you can't feel it? The motor is going to have a t76 running 6-8lbs boost on it.

And if you think I should get them worked on can someone recommend a good shop in Denton area.

[racrguy]

I wouldn't worry about it, IMO. I'm an NA guy though, so I'd defer final judgement until one of the guys that deals with boost regularly chimes in.

[Rreemo]

If you can't feel it, I'd personally clean up the entire surface with a scotch-brite pad and see how it looks then. I usually use the brown 2" pads for stuff like this on my 90-degree air grinder.

If you are looking for a shop in Denton, hit up Wayne Calvert - http://www.waynecalvertengines.com/

[Veight7]

K thanks guys. I'm I'm the same boat this is my first venture into boost. And holy crap sorry about the massive pic. I uploaded imageshack on my phone no size choice.

[Rreemo]

I'm no Brooks, but I've messed with boost a bit and I think you'll be fine after you clean that up yourself.