Announcement

Collapse
No announcement yet.

Steering shaft rubbing headers...

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Steering shaft rubbing headers...

    I have Mac EL shorties and the MM solid steering shaft. The shaft is rubbing the header a tiny bit. More annoying than anything else...

    Motor mounts were replaced a year ago...

    Any other ideas?

    Sent from my SAMSUNG-SGH-I747 using Tapatalk 2
    Tags: None
  • #2
    Mark where the steering shaft is hitting the header, take header off, heat it up, and beat the header in some with a hammer to clear the shaft?
    1991 5.0 Mustang LX-Hatch, BBK Cold Air Intake, BBK Headers, BBK X-Pipe, Flowmaster 40's, HPM C/C Plates, Cobra Sway-Bar, UPR Subframe Connectors, UPR Control Arms, FRPP Aluminum Driveshaft, FRPP "C" Springs, FRPP 31 Spine Diff, Moser 31 Spline Axles, FRPP 3:73 Gears, Tokico Blue Shocks, King Cobra Clutch, MSD Ignition, Taurus Electric Fan, BBK Gripp Shifter, & More

    Comment

    • #3
      I have a small spacer under my engine mount on that side to give me clearance

      Comment

      • #4
        I put a couple washers in between my collumn and dash mounting to move the end a bit to clear the 32v in the mont.
        "If I asked people what they wanted, they would have said faster horses." - Henry Ford

        Comment

        Previous template Next
        Working...
        X