Axle bearing help!

[inline 6]

While putting my rear end back together on my jeep from doing a gear swap I was putting my passenger axle back in and noticed that a little ring was hanging loose on the shaft. After some research I see that it is from something between the backside of the bearing and the seal. I need to replace the bearing as it appears to have been originally connected there. Can anyone with the tools to get the bearing off and a new one on help me this weekend? I can bring the axle shaft to you asap.

Thanks and I really need some help as I have to have this back on the road by Mon

[jyro]

o'reilly auto parts

[inline 6]

I am in Midlothian myself and I just called up there and they had no clue. They have the bearing but do not seem to have any way to pull the old one off or put a new one on.

[Shockeruti]

Can you take a picture of the ring? I'm in midlothian. Toss me a pm if u need a hand.

[Baron Von Crowder]

Bearing race?

[stephen4785]

I cut them off with a die grinder and press the new one on with a block of wood and a hammer.

[Lone Star Performance]

Slide hammer with a bearing removal tool on the end

http://www.harborfreight.com/rear-axle-bearing-puller-set-66380.html

[stephen4785]

Slide hammer with a bearing removal tool on the end

http://www.harborfreight.com/rear-ax...set-66380.html

That tool works for axles without c-clips. Im pretty sure his has a bearing pressed on the axle and not in the housing like this.

http://stu-offroad.com/axle/d44/d44-2.jpg

[stephen4785]

I can swap it out for you but Im in Benbrook so it´s a decent little drive for you.

[inline 6]

Jyro saved the day and he was only 5 minutes away.

Thanks for the offer though.