6spd in a fox question

[blownaltered]

Yeah that or the T56 units I said I have available. They have a 9 O'clock fork position. I can also do a custom unit which is basically a Viper spec model that uses a 26 spline input shaft, 31 spline output shaft, mechanical speedo and has the correct fork position but it runs about $3200 to build one and that doesn't include the bell housing.

What type of bellhousing would I have to use. I assume I would have to have my driveshaft shortened, find a cross member, clutch and what else would I need.

[thesource]

What type of bellhousing would I have to use. I assume I would have to have my driveshaft shortened, find a cross member, clutch and what else would I need.

If you want an SFI bell housing, you'd go with a RM8030
Driveshaft needs to be cut down about 1.5"
Crossmember is available through Stifflers or AJE
Clutch, any 10 spline kit you like
Extended speedometer cable

[twisted93coupe]

Hey blownaltered put a hydrolic throw out bearing in it instead of using a fork

[blownaltered]

Hey blownaltered put a hydrolic throw out bearing in it instead of using a fork

Not interested in converting to a hydrolic clutch. I'm going to make my decision today on what I'm doing and get everything on order

[01svtboy]

my buddy has a one from a t/a, fresh rebuild sitting on a shelf at his trans shop. he wants 900 if anyone is looking....