Announcement

Collapse
No announcement yet.

For the haters and second guessers, bench racers and more.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Originally posted by 91CoupeMike View Post
    didn't burn oil, smoke or misfire... wet plug #8 and smoke maybe once a month if I engine braked to a stop.
    K.
    2014 GT
    2013 FX2 ecoboost

    Comment


    • Originally posted by Slow Five-O View Post
      K.
      "K"
      Ring and pinion specialist

      Comment


      • Saying it a second time, although it's too late now...two words...BLOCK TEST! I blew headgaskets on my turbo car and neither one did any damage to the fire ring. They looked very similar to the pics you're posting....just not as bad. Combustion gases pushing over the top of the fire ring, damaging the gasket. Both with a failed BLOCK TEST. It's the first thing I'd do if I even remotely thought I had a bad gasket. The solution was ARP head bolts and ultimately different heads than the stockers.

        Comment


        • I say go fot it Mike.
          Doug

          90 LX Coupe 5.0
          90 7up Vert. 5.0

          Comment


          • You going to pop the #8 piston out and check the rings? or just hope it was the valve seals only?

            Comment


            • Originally posted by Pooter View Post
              You going to pop the #8 piston out and check the rings? or just hope it was the valve seals only?
              2014 GT
              2013 FX2 ecoboost

              Comment


              • .K.

                Comment


                • Originally posted by racrguy View Post
                  Ignore the melted plug, and the bubbling coolant.
                  I meant the incredibly ironic double negative, but yes

                  Comment


                  • Originally posted by 90GT50 View Post
                    I meant the incredibly ironic double negative, but yes
                    "K"

                    Comment


                    • I use standard angle cut scrapers or a carbon steel square edge scraper and 3m rotorloc discs, usually the green ones. The square edge scraper is amazing, the machine shop I use in Midland ordered them for a friend and myself. I was pretty skeptical of how it would work initially, but after a little use learned it would be my "go to" tool for scraping and cleaning needs most of the time. The rotoloc disc make good sharpening tools when the fingers get worn down to near nothing, I also use them to roughly polish steel parts.

                      square edge scraper http://www.goodson.com/SS-4U-1-1_4_Wide_Super_Scraper/

                      3m rotoloc http://www.3m.com/product/images/Bristle-Discs-300.jpg

                      Comment


                      • Fuck spay some of this on the gasket and run the mofos
                        \/\/
                        Last edited by rz5.0; 02-01-2013, 06:18 PM.

                        Comment


                        • Originally posted by rz5.0 View Post
                          Fuck spay done of this on the gasket and run the mofos
                          "K"




                          Wtf??? English mother fucker!

                          Comment


                          • Comment


                            • Originally posted by Mysticcobrakilla View Post
                              "K"




                              Wtf??? English mother fucker!
                              Fuck you.. its my phone..

                              Comment


                              • Just cus I'm fucking yours doesn't make me a mother fucker...


                                Wait... Yes it does...

                                Comment

                                Working...
                                X