upper control arms

[TEAMJACOB]

i am putting stock ones back on my car. the side of the control arm that mounts to the rear end slides over thin mount with a hole in it. since that mount is about half an inch wide but the control arm is about 2 inches across. is there something that goes in between all that

[dville_gt]

did you put different mounts in the housing?

[TEAMJACOB]

did you put different mounts in the housing?

i didnt. i had aftermarket ones done a while ago and i am pulling those off to sell and need stock ones back on to roll the car around

[CWO]

I recently learned that stock UCA's are different for FOX cars vs. SN95 cars. A little foggy on the details, but they are different in some way. Maybe you have SN arms? ... in which case I'll take them, cuz I need a pair

[TEAMJACOB]

ok my phone is deal so this is a google image. mine are stock so bare with me

[TEAMJACOB]

the two sides that are going to slide over the mount are further apart than the mount is wide. also on my car, i dont have that bushing that is picture in above. is my car suppose to have a bushing there

[Mysticcobrakilla]

^^^ that's a s-197 uca. Not even close to a fox

[dville_gt]

the two sides that are going to slide over the mount are further apart than the mount is wide. also on my car, i dont have that bushing that is picture in above. is my car suppose to have a bushing there

yes, you should have a bushing of some sort (either rubber, urethane, or spherical)

[CWO]

missing that rubber bushing in the rear end explains it

[TEAMJACOB]

^^^ that's a s-197 uca. Not even close to a fox

i know but it was quick search. id take actual pics but my phone is chargin

yes, you should have a bushing of some sort (either rubber, urethane, or spherical)

ok for a fox also right?

missing that rubber bushing in the rear end explains it

ok now to find one of those

[white88]

http://www.maximummotorsports.com/store/index.php?main_page=product_info&cPath=514_21_99&products_id=543

[CWO]

RAYBESTOS Part # 5701049

I'd get both

[Mike]

How much for the roller?

I have nothing else to add here.

[Exile]

yes, you should have a bushing of some sort (either rubber, urethane, or spherical)

missing that rubber bushing in the rear end explains it

ok now to find one of those

Ford Racing Rear Upper Axle Bushing Kits M-4050-B
http://www.summitracing.com/parts/fms-m-4050-b