Any one here run AN fittings on their radiator hoses

[ktm300hater]

Just for kicks I made this to run -20 AN fittings, still need to weld the bungs on the radiator

[greenbullitt]

yes, we have,but we use an oem tstat housing so you can utilize a t stat

[Matt]

i run -16an on my honDUH

[Grape]

wiggins clamps on the water and oil hoses on the race cars.

[racrguy]

I use 4 -10 lines for my car to each corner of the intake. Works pretty good.

[mk5.0]

wiggins clamps on the water and oil hoses on the race cars.

I thought you hated wiggins clamps ?

[turbostang]

If you run any kind of car with any kind of power, especially forced induction cars - there's no excuse to not have screw on hoses.

[Big Dad]

Yep

-16 here

[KBScobravert]

I use a -16an upper and lower hoses and is a street car.

CSI-16 Ford T-stat housing, bungs welded to the radiator, -16an bung fits perfect into a factory Ford water pump inlet.

We also use -8 and 10 for the heater core also. Removed ALUMINUM core, cut the tubes down, welded -8 and -10 male bungs to them. Drill rear water jacket in the intake, welded a -8an male bung. Pulled the 5/8" pipe out of the water pump, taps perfect with a 1/2" NPT, then threaded a 1/2"-10an adapter.

There is not a single hose clamp on my car and it is full P/S and A/C motor with probably 2+ seperate lines. Way too many hose ends but never have to worry about a leak.

[Mach1]

wiggins clamps on the water and oil hoses on the race cars.

choooo$$$$$ choooo$$$