Announcement

Collapse
No announcement yet.

My experience with TrueStreet

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Originally posted by turbostang View Post
    FWIW, One more thing - I've taken many cars apart that have NOT had a dowel pin (in the flywheel) and if I didn't tell you, you'd never know. It doesn't make it right or wrong, i'm just saying.

    Those bolt holes in a flywheel are close tolerance, and likely only have about
    .015" clearance, if that. Meaning, that it's unlikely (but possible) that it's causing a severe enough vibration to tear it back down.

    I would be much more concerned about missing dowels in the belhousing and pressure plate - that's where the real runout and unbalance potential is at.

    Brooks, I believe the dowel pins that references are being made to are the ones in the flywheel that center the pressure plate. The previous thread posted by teamjacob, and I believe in the beginning of this tread show pictures of the flywheel bolted to the motor with the pressure plate removed and no visible pressure plate locating dowels.

    Comment


    • Originally posted by Mach1 View Post
      Kyle would never drive or be seen in a faggy yellow miata like I have
      you are now and will forever be kyle

      anything you say to try to argue will only be further prove that you are kyle

      just ask talisman and a bunch of other idiots around here lol .

      but jokes aside you screwed up chris (since we all call each other by our first names here i guess

      you screwed up chris when you took it to the other shop that is what will cost you the lawsuit

      if you had just took it back to him and its was it turned out to be his fault he could not have lied

      Cause you would have just took it over to the machine shop to check his excuse and they would have proved you right

      Comment


      • just want to clear up the "tsm 5.85 tune?" tag.

        the 5.85 designation is in no way affiliated with truestreetmotorsports or any of their subsidiaries. the use of the 5.85 designation must be used with permission of dreamteamtuners incorporated. unauthorized use of 5.85 designation holds a minimum sentence of 6 months, but not to exceed 12 months of not running another 5.85.

        Comment


        • Originally posted by waycooljr View Post
          you are now and will forever be kyle

          anything you say to try to argue will only be further prove that you are kyle

          just ask talisman and a bunch of other idiots around here lol .

          but jokes aside you screwed up chris (since we all call each other by our first names here i guess

          you screwed up chris when you took it to the other shop that is what will cost you the lawsuit

          if you had just took it back to him and its was it turned out to be his fault he could not have lied

          Cause you would have just took it over to the machine shop to check his excuse and they would have proved you right
          Fuck you, you stupid cunt.
          Originally posted by PGreenCobra
          I can't get over the fact that you get to go live the rest of your life, knowing that someone made a Halloween costume out of you. LMAO!!
          Originally posted by Trip McNeely
          Originally posted by dsrtuckteezy
          dont downshift!!
          Go do a whooly in front of a Peterbilt.

          Comment


          • Originally posted by dville_gt View Post
            just want to clear up the "tsm 5.85 tune?" tag.

            the 5.85 designation is in no way affiliated with truestreetmotorsports or any of their subsidiaries. the use of the 5.85 designation must be used with permission of dreamteamtuners incorporated. unauthorized use of 5.85 designation holds a minimum sentence of 6 months, but not to exceed 12 months of not running another 5.85.
            2012 GT500

            Comment


            • I did take the car back to him where he said is was the vibration.
              Then I asked if he would at least back the transmission off.
              So, should j gave gotten something on writing about reimbursement if another shop found them faulty?

              Comment


              • Originally posted by TEAMJACOB View Post
                I did take the car back to him where he said is was the vibration.
                Then I asked if he would at least back the transmission off.
                So, should j gave gotten something on writing about reimbursement if another shop found them faulty?
                Who is J?

                Comment


                • Originally posted by BMCSean View Post
                  Who is J?
                  I started this thread with out emotion or being upset. Too much time has passed and it was in response to Clint avoiding my pms and phone calls. I just couldn't figure why you were trolling me so hard but I just figured it out

                  Comment


                  • Originally posted by TEAMJACOB View Post
                    I did take the car back to him where he said is was the vibration.
                    Then I asked if he would at least back the transmission off.
                    So, should j gave gotten something on writing about reimbursement if another shop found them faulty?
                    No offense but I remember your original thread about this and it was somebody else's idea to do that and that was recently. You also don't know where your rear main seal is so I don't think you came up with that idea on your own.

                    Comment


                    • You are correct. Clint said its the motor so I went home. That was suggested, which a professional shop would have already known to do long before I asked. So I asked in the phone conversation and it was still refused. So I had another shop do it just be sure. I'm glad I didn't have the motor pulled out before doing it and finding out the motor was good. I think Clint jumped the gun on wanting to pull the motor again with out checking the fly wheel. If there is a balance issue, doesn't a professional shop check the flywheel and balancer before rebuilding a motor? From what I have since learned, it's pretty common knowledge

                      Comment


                      • Originally posted by TEAMJACOB View Post
                        I started this thread with out emotion or being upset. Too much time has passed and it was in response to Clint avoiding my pms and phone calls. I just couldn't figure why you were trolling me so hard but I just figured it out

                        ?? I troll pretty much everyone, but you are easy.....

                        If you are referring to my location you are off base, I don't have any skin in the game and won't pick a side, everything I post is my personal opinion of the situation at hand. I have had work done I wasn't happy with but you won't find a thread about it. It wasn't done at TS FYI, I've never even been there.

                        Comment


                        • I think the shop is going to slide on covering anything more based on teamjacobs online persona than anything else. The guy came up with the $5400 to pay them for the work they did, if they fucked up and didn't put the pins in, they need to step up and cover it.

                          Comment


                          • Originally posted by Mike View Post
                            I think the shop is going to slide on covering anything more based on teamjacobs online persona than anything else. The guy came up with the $5400 to pay them for the work they did, if they fucked up and didn't put the pins in, they need to step up and cover it.
                            That's why I keep saying take it to court. I think he'll be payed his expenses on fixing what was messed up. It should have been done right, it wasn't, he had to pay out of pocket to fix things that he'd already shelled out 5 grand for. Paid advertiser or not, it's wrong.
                            Last edited by BradM; 11-28-2012, 08:27 PM.

                            Comment


                            • So his screen name is some reference to those twilight movies? He should've bought a Volvo.

                              Comment


                              • I have had excellent service from TMS and will continue to go back there. I am sure that this thread will be copied for future reference. I hope that you are happy with some of the remarks you have made, but I don't think they were necessary. I have bought parts from you Chris, and thought you were pretty level headed, but this action makes me wonder.

                                Everything okay Chris? You made bro?

                                Comment

                                Working...
                                X