help , 5.4 main stud question

[eric 2v gt]

so i just got my motor back from the machine shop, freshened up, honed, new rod bearings , piston rings, yada yada, ok so i was going to install the pick up tube and it just so happens that the extended main stud for the pick up tube is in the wrong spot, what do i do , can it be swap, then just re torque the two studs or does the whole torque sequence need to be redone?
whats the best way to approach this problem , thanks

its a 5.4 mod motor

[JC316]

I would just take it out and torque it normal.

[eric 2v gt]

as in do the whole sequence over , or just re torque the two studs

[Rick Modena]

I would just re torque the two.

[eric 2v gt]

ok thanks guys

[JC316]

as in do the whole sequence over , or just re torque the two studs

Just torque the two. Sorry I wasn't clear.