School Me on Different Injectors(60+lb/hr) and a Big Mass Air

[payne5757]

With a real block to make some real power on it's way, I will be upping the fuel system in my car. I will be aiming for 650ish rwhp. Im thinking 60lb/hr injectors but with all of the different styles available, I dont know which ones to use on my car. Are my injector plugs EV1 style? Which injectors would be plug and play on my car? I also want to step up to a 90mm or bigger mass air. What is required to run, for example, one of the big Lightning style Mass Airs on a Fox Body?

[Diabolic]

You want an 05 and up slot meter in a 3" or 3.5" tube. You want 60 or 80# Siemens injectors with EV1 plugs.

[payne5757]

Is the slot meter a plug and play or will it even run without tuning?

[Sleeper]

For the price of the meter your halfway to a megasquirt imho. Ditch the maf.

[Diabolic]

I it has to be tuned. It's plug n play with an RJM adapter harness. At least from a wiring standpoint.

[Blackpony]

I would use the ford racing injectors along with an sct maf. something like a ba3000

[payne5757]

What about an 85mm throttle body? Is accufab the only company that makes big TBs?

Sent from my cellular portable phone device

[green1995gt]

What about an 85mm throttle body? Is accufab the only company that makes big TBs?

Sent from my cellular portable phone device

Edlebrock makes big ones I have a 90mm on mine.

[green1995gt]

You can buy lightning meters and the wiring harness you need to swap over on ebay for fairly cheap. I bought the lightning meter and then Josh at JKS made a fitting on 4inch stainless pipe for the sensor to go into. so I dont have a mass air meter between my tubing its inside it.

[payne5757]

Edlebrock makes big ones I have a 90mm on mine.

Whats the approximate power level support per throttle body and mass air size? If my ultimate goal is maybe 750rwhp, would a 92mm mass air and 90mm TB support that?

Sent from my cellular portable phone device

[payne5757]

Bump

Sent from my cellular portable phone device

[green1995gt]

Whats the approximate power level support per throttle body and mass air size? If my ultimate goal is maybe 750rwhp, would a 92mm mass air and 90mm TB support that?

Sent from my cellular portable phone device

I dont know, I have it on a 393 stroker motor but I put too small of heads on it but I know it flows good enough on my motor, I would think it would work with forced induction too.