Felpro mls

[robert]

Who sells them locally?
Yes my oil is Mocha Latte

[Txstang1]

Lonestar my have them in stock, if not check with HPW.

[robert]

Thanks,
Hoping for a bit more local like in N.Ft Worth
Not sure what or where is HPW

[Txstang1]

Sorry, didnt notice your location. Gearheads maybe? HPW is in Garland.

[mk5.0]

American gasket off 30 should have them.

[robert]

migjht just order them
What part number are you guys using?
Vic jr heads

[payne5757]

I just ordered them for my new motor but they are 4.180 bore. What bore size?

Sent from my cellular portable phone device

[robert]

4.10 for what i know, which is not much.
for my CHP 347 vic jr heads. thx

[payne5757]

1133 gaskets. http://www.jegs.com/i/Fel+Pro/375/1133/10002/-1

Sent from my cellular portable phone device

[robert]

1133 gaskets. http://www.jegs.com/i/Fel+Pro/375/1133/10002/-1

Sent from my cellular portable phone device

Thanks for that tip! appreciate it

[Blackpony]

If it is a stock block, i wouldn't spend the xtra money on a mls gasket. A 1011-1 will be perfectly fine for half the cost.

[robert]

If it is a stock block, i wouldn't spend the xtra money on a mls gasket. A 1011-1 will be perfectly fine for half the cost.

Appreciate you chiming in
Can you please ellaborate?
It is a Stock Mexican block
EFI wet Nitrous (almost 200 shot) 347 RPMII Vic Jr Heads APR Studs
Old shop in FL said to get the 9333pt1 gaskets
tia

[Blackpony]

Appreciate you chiming in
Can you please ellaborate?
It is a Stock Mexican block
EFI wet Nitrous (almost 200 shot) 347 RPMII Vic Jr Heads APR Studs
Old shop in FL said to get the 9333pt1 gaskets
tia

I have run the 1011-1 gaskets on 800+ hp nitrous motors in the past with 0 issues. An mls gasket is a great gasket and has its place, but it is just overkill by a long shot for what you have. Save yourself some money. You will have block problems before you have gasket problems. (so long as both surfaces are true and flat when assembled) I would not suggest the 9333 since you are running nitrous, I have seen troubles with that gasket and the high cylinder pressures nitrous provides.


Two of these and you are set! Be sure and use arp moly lube when torque those studs.

http://www.summitracing.com/parts/FEL-10111/

[robert]

I have run the 1011-1 gaskets on 800+ hp nitrous motors in the past with 0 issues. An mls gasket is a great gasket and has its place, but it is just overkill by a long shot for what you have. Save yourself some money. You will have block problems before you have gasket problems. (so long as both surfaces are true and flat when assembled) I would not suggest the 9333 since you are running nitrous, I have seen troubles with that gasket and the high cylinder pressures nitrous provides.


Two of these and you are set! Be sure and use arp moly lube when torque those studs.

http://www.summitracing.com/parts/FEL-10111/

Gotcha-thanks for the info really appreciate it.

[greenbullitt]

1011-2 is recommended for aluminum heads