Slicks

[bonnie&clyde]

after spinning badly at the cruise i want to go ahead and get some some track wheels, i currently have 94-95 rear axles in my fox so with that said what wheels and tire size could i go with without rubbing the fender and tearing up the tires? TIA

[Dacotua]

after spinning badly at the cruise i want to go ahead and get some some track wheels, i currently have 94-95 rear axles in my fox so with that said what wheels and tire size could i go with without rubbing the fender and tearing up the tires? TIA

Without knowing your offset of your wheels, put 8" wide slicks on the back. However with a Manual car, you will want to upgrade the rear axles or you may bend or snap one.

Honestly if you are concerned about spinning the tires, it's time to upgrade your suspension.

[bonnie&clyde]

Yeah I was planning on upgrading it aswell but still debating on what all I wanna do to it

[sickpony]

7.5 inch backspacing on the wheels will do the trick

[sdun]

28x9 will take you a long way. Call brian at lonestar. He knows everything about fox cars. He can tell you what tire and wheel will work for your car.

[joes01bullitt]

what did you end up running at the track anyway?

[bonnie&clyde]

8.8

[joes01bullitt]

Damn what was your 60ft?

[bonnie&clyde]

idk i forgot, ill have to look for my ticket

[robert]

My .02c
Depends on many variables:
Power-gear ratio, suspension, Drivetrain.
If you have a T5 I would start with a 26" tire.
I used to run a 27" with a T5 and 125 shot would run into clutch slippage issues.

[bonnie&clyde]

here is my current set up, 3.73 gears, bilstein struts, lower MM control arms, Upper Ford racing control arms, tko600 tranny, N/A motor for now until turbo later, also have 13inch brakes and 3 inch tail pipes