Anyone know of a good Honda shop in Lewisville? I have a 1995 Civic that needs some work. It's running like poo poo.
Announcement
Collapse
No announcement yet.
Need a reputable Honda shop in Lewisville.
Collapse
X
-
It is hesitating/shaking and struggles to accelerate through the lower RPM range. The coil, plugs, wires, dist cap, catalytic converter are all pretty new. I'm thinking it may be fuel pump related or an o2 sensor. I don't have the space or the time to jack with it though. That's the real problem.
Comment
-
David Mcdavid Honda in Irving. Don't know how far it is for you but I have driven my wifes civic there from Crowley to get it worked on. Like 60 miles one way. I live in Joshua now and wouldn't hesitate to drive it there 70+ miles cause they've always done me right.
Comment
-
CEL light? At least do a test. The jumper is just to the bottom right of the glove box. It should be in a rubber green thing. There are two blue (sometimes gray) plugs, the 2 wire blue plug is the one you want to jump.
Turn off the car, jumper the 2-wire blue plug. Turn key to ign. The CEL will blink once, then start spitting codes. The LONG flashes are the 1x and the short flashes are the x1 spot.
Two long and 3 short = 23.
Honda Civic / Del Sol (1992 - 2000) - How To Pull CEL, D4, SRS, and ABS Codes (with Code Lists) - Abbreviations CEL = Check Engine Light in gauge cluster D4 = Automatic transmission D4 light in gauge cluster SRS = Supplemental Restraint System (Airbags) light in gauge cluster ABS = Anti-Lock Brake System light in...
OBD1 CEL code List
0- code 0 is defined by the CEL remaining on steady both without and with the service connector jumped. If the engine will not start, code 0 indicates that the ECU is not receiving power and/or ground. In this case, begin by checking (1) fuses 24 and 31 (92-95 Civics) or fuses 13 and 44 (96-00 Civics), (2) the main relay, and (3) the G101 ground attached to the thermostat housing.1 O2A - Oxygen sensor #1
2 O2B - Oxygen sensor #2
3 MAP - manifold absolute pressure sensor
4 CKP - crank position sensor
5 MAP - manifold absolute pressure sensor
6 ECT - water temperature sensor
7 TPS - throttle position sensor
8 TDC - top dead centre sensor
9 CYP - cylinder sensor
10 IAT - intake air temperature sensor
12 EGR - exhaust gas recirculation lift valve
13 BARO - atmospheric pressure sensor
14 IAC (EACV) - idle air control valve
15 Ignition output signal
16 Fuel injectors
17 VSS - speed sensor
19 Automatic transmission lockup control valve
20 Electrical load detector
21 VTEC spool solenoid valve
22 VTEC pressure valve
23 Knock sensor
30 Automatic transmission A signal
31 Automatic transmission B signal
36 traction control found on JDM ecu's
38 Secondary vtec solenoid on JDM 3 stage D15B Vtec ECUs (P2J)
41 Primary oxygen sensor heater
43 Fuel supply system
45 Fuel system too rich or lean
48 LAF - lean air fuel sensor
54 CKF - crank fluctuation sensor
58 TDC sensor #2
61 Primary oxygen sensor
63 Secondary oxygen sensor circuit
65 Secondary oxygen sensor heater wire (black wires)
67 Cat Converter
70 Automatic transmission problem
71 random misfire cylinder 1
72 random misfire cylinder 2
73 random misfire cylinder 3
74 random misfire cylinder 4
80 EGR Valve/Line
86 ECT sensor - Cooling System
90 Evaporative Emission Control System Leak
91 Fuel Tank pressure sensor
92 EVAP Solenoid/Valve/Vacuum Lines
Comment
-
-
Originally posted by Brandon-k View PostIt gradually got worse over the course of a few weeks until I finally parked it and quit driving it.
Comment
-
-
Originally posted by big_tiger View PostKinda, I still put my money on distributor over fuel pump. What kind of distributor did you buy?
Comment
Comment