Anyone got a beam style in/lb torque wrench?

[dville_gt]

So I need to install a new crush washer on my pinion (replacing pinion flange with a 1350 yoke) and don't have a 1/4in beam style torque wrench. Anyone got one (preferably close to N. Arlington).

Thanks!

[KBScobravert]

So I need to install a new crush washer on my pinion (replacing pinion flange with a 1350 yoke) and don't have a 1/4in beam style torque wrench. Anyone got one (preferably close to N. Arlington).

Thanks!

Mine is 3/8" needle style and I have an inch pound click type in 3/8" also.

When I get home I will snap a pic and see if it is what you need. I will be home tomorrow in the garage from 9-2 if you want to swing out to Haslet (think 10 minutes from CTD) to get it.

[dville_gt]

For sure, if you could check and see on the needle style if it goes down to 15-20in/lbs.

Thanks

[greenbullitt]

hey fucker, I told you id help you

edit, just got my pm lol

[kidcapri]

hey fucker, I told you id help you

edit, just got my pm lol

Those sure are some nice TITS in your avatar.

[greenbullitt]

Those sure are some nice TITS in your avatar.

lol, second comment today!

[kidcapri]

lol, second comment today!

Do you make payments on those? If so, I would consider a "take over payments deal"

[kidcapri]

lol, second comment today!

I would have to see them with NO bra first...........just to make sure they don't look like a D battery in a tube sock!!!!

[80coupe]

i would have to see them with no bra first...........just to make sure they don't look a d battery in a tube sock!!!!

lmao

[KBScobravert]

For sure, if you could check and see on the needle style if it goes down to 15-20in/lbs.

Thanks

Mine did not go that low.

Sent from my SAMSUNG-SGH-I727 using Tapatalk