ARP head bolt torque specs?

[Blue88Coupe]

for a 5.0 with ARP head bolts (1/2 head size) what are the torque specs? I think ARP is closed today. The website says 110 but that seems high and i know there were some steps before torquing them all the way down.

Thanks
-Nick

[Mach1]

What block?? 5.0 is 7/16 unless its a aftermarkrt block. I tq 1/2 to 100 and 110 on intake side

[Blue88Coupe]

What block?? 5.0 is 7/16 unless its a aftermarkrt block. I tq 1/2 to 100 and 110 on intake side

stock block 5.0

I found the arp box its a 154-3605 SB Ford302W but the torque instructions are not in it

[Txstang1]

90-95 ft lbs. I usua.lly go with 95

[Blue88Coupe]

90-95 ft lbs. I usua.lly go with 95

I think mine are the 200,000 psi bolts. According to here i should have them on 80ft lbs

http://www.arp-bolts.com/pages/technical_torque_us.shtml

[2cammer97]

I recently added GT40 heads to my '92 using ARP bolts. I used 80 ft-lbs. I used 10-30 wt oil on the top bolts and the arp sealant on the bottom bolts.

I went in increments of 30-50-60-70-80 and you have to torque the bolts in the proper order. Do you have a shop manual, it shows the proper bolt sequence.

Marcus

[Txstang1]

I think mine are the 200,000 psi bolts. According to here i should have them on 80ft lbs

http://www.arp-bolts.com/pages/techn...orque_us.shtml

I see, well I would split it and torgue them at 85lbs. You will be fine with whatever you decide to do. Is it a high horsepower motor?

Also, go 50lbs, 70lbs, 85lbs.

[Blue88Coupe]

I see, well I would split it and torgue them at 85lbs. You will be fine with whatever you decide to do. Is it a high horsepower motor?

Also, go 50lbs, 70lbs, 85lbs.

Its a low horse power junk yard motor. I just put them straight to 80 inside to outside