Quick run down:
A buddy of mine who is deployed asked me to replace the window motor/regulator on his '01 Durango. That was fine. Yesterday I went to re-install the interior door panel (passenger front). Before I installed any of the fasteners, I tried to run the door lock and door handle (interior and exterior) through just to make sure shit was kosher. It wasn't. Yes, I had the right rods installed in the right spots on the door panel (on this particular truck, the bottom rod goes to the lock and the top to the interior handle) and yes I had the plug for the door lock switch plugged in. For whatever reason, though, when I install the door panel, the lock rod and door handle rod are getting stuck and won't actuate. I can't exactly see or feel what's going on, so I'm trying to get any suggestions from those who have run in to this situation before.
A buddy of mine who is deployed asked me to replace the window motor/regulator on his '01 Durango. That was fine. Yesterday I went to re-install the interior door panel (passenger front). Before I installed any of the fasteners, I tried to run the door lock and door handle (interior and exterior) through just to make sure shit was kosher. It wasn't. Yes, I had the right rods installed in the right spots on the door panel (on this particular truck, the bottom rod goes to the lock and the top to the interior handle) and yes I had the plug for the door lock switch plugged in. For whatever reason, though, when I install the door panel, the lock rod and door handle rod are getting stuck and won't actuate. I can't exactly see or feel what's going on, so I'm trying to get any suggestions from those who have run in to this situation before.
Comment