Driver side low beam not working on 03 super duty

[5.0 n it]

Ok guys I've google searched, poked through, and re-checked all the fuses and swapped bulbs and still the driver side low beam will not work, both high beams come on but no low beams at allllll!!! Just checking to see if anyone in here has been through the same headache, any help would be appreciated, thanks guys

[The King]

A relay possibly?

[5.0 n it]

A relay possibly?

From What I've researched, these boogers don't have a relay for the headlamps, retarted I know

[psdtech]

Check the connector at the head light. Seen a few burn up the pins

[Rick Modena]

Check the connector at the head light. Seen a few burn up the pins

This, and also check for the ground, they get corroded as well.

[JimD]

CJB fuse 47 (10amp) is for left low beam headlight according to alldata.

[5.0 n it]

Well I "know" the ground "and" the pins are "not" the culprit, i tied onto the passenger side lowbeam and ran it to the driver side lowbeam, and bam! It works,, but that's only a temporary fix, which leads me to believe the lowbeam wire must be fried, again, I've checked all the fuses and even probed my test light to them and they all show to be good. Anymore suggestions here guys?

[psdtech]

check fuse 46 under the dash for power and ground 100 on the left side of the fire wall. if not you may have a burnt up (or loose) fuse box, its a solid wire from the fuse to the light.

[astang95]

does it have a lighting control module?

[astang95]

Check fuse 2.7 30A and 2.17 15A, straight from the workshop manual

[astang95]

you might also check the multifunction switch, Ive seen pins fall out of the connectors due to brittleness, and on the wiring diagram, it passes through the multifunction switch.