Oil pan gasket on a fox???

[91CoupeMike]

I did mine without raising the engine... but I've got a tubular K-member that allowed just enough room to fish the one-piece gasket through.

Lucky, I'll invest in a team z k member here soon.

[dville_gt]

Lucky, I'll invest in a team z k member here soon.

if i were planning to do a k-member in the near future i'd just wait. it'll be a HELL of a lot easier with the k-member out.

[71chevellejohn]

Lucky, I'll invest in a team z k member here soon.

I really like my AJE K-member.

[91CoupeMike]

I really like my AJE K-member.

The team z are 289$ they are not choromoly though. The chromoly ones are closer to 400.

[71chevellejohn]

http://www.ajeracing.com/

$280 for the k-member
$70 for the engine plates - If you decided to change engine type later, you just need a different set of plates.

[91CoupeMike]

http://www.ajeracing.com/
$280 for the k-member
$70 for the engine plates - If you decided to change engine type later, you just need a different set of plates.

Damn, late model had the listed at 100$ mark up..

[91CoupeMike]

Question I had in general, I can still use my solid mounts on a tubular k member right?

[fordracing19]

Question I had in general, I can still use my solid mounts on a tubular k member right?

Yes. If you are swapping k members just continue to add oil to it.
Sent from my iPhone killer!

[71chevellejohn]

Question I had in general, I can still use my solid mounts on a tubular k member right?

The AJE does away with the standard engine mounts. There is a poly-isolator in the mount to dampen vibrations.


The engine plates bolt to the block and they have tabs that come down over the k-member mounts(shown above).
With the plates, Without the engine: