What I have been working on

[KBScobravert]

I had Diablo Rojo "Matt" at Powder Works and his guys powder coat some of my rear end parts. I should have had him do the entire rear end housing...

They did the caliper mounting brackets, anti-moan plates, tension rods and the rear end cover. Their red matched the other red suspension parts perfectly.

I can't wait to get this thing together and up in the car.

[KBScobravert]

Paul (greenbullet) came over and assembled the rear and we got it in the car along with the transmission.

I have to go through all the suspension and tighten the bolts and set the instant center and ride height. Still lots of work to do but this was the hard stuff getting the rear and trans up in there.

[Z06killinsbf]

Looks fuckin tits man

[Fastlane]

That looks badass.

[KBScobravert]

Front struts arrived. Too bad I leave tomorrow morning.

[Mysticcobrakilla]

Those look nice!

[KBScobravert]

Those look nice!

Phenomenal quality. Only small gripe is that they do not come with new nyloc nuts for the strut top. Not a big deal, probably cost me $1.50 for 2 but I'll hand carry one into Ace Hardware to verify the threads since I don't have a nut in my bin that matches.

[Mysticcobrakilla]

I'm gonna have to look into them. I know jack shit about Viking.

[Sleeper]

Send them to me for testing

[Broncojohnny]

We put the coil overs and LCAs on Mike's car, we got it at around a 26"-27" ride height and it handles like it is on rails already. Panhard bar goes on this weekend. Torque arm will be later once he gets some subframes.

That Viking stuff looks nice, man.

[KBScobravert]

We put the coil overs and LCAs on Mike's car, we got it at around a 26"-27" ride height and it handles like it is on rails already. Panhard bar goes on this weekend. Torque arm will be later once he gets some subframes.

That Viking stuff looks nice, man.

Glad to hear. PM me if you guys have any questions on the PHB.

[KBScobravert]

Send them to me for testing

Damn. Too late. Already in the car.


Had to carry one into the hardware store to get the thread size for the top mount. Good thing, damn thing is an M16-2.00.

Not sure how this is going to work out once everything is right asnd aligned. Sure looks close to the away bar links.

[terminator03]

I run the same coil overs Viking is good shit

[KBScobravert]

I run the same coil overs Viking is good shit

Any problems with them clearing the sway bar links?

[Scott Mc]

Shorter stay bar links lol.