plasma cutter repair

[sickpony]

I have a matco plasma cutter that powers up and trigger works air but does not cut. Anybody know where I can take this unit for service? I have no local matco dealer and I live east of dallas so hopefully somewhere in the immediate dallas area.

[DFWtechie]

It sounds like the high frequency board is bad. I had few go out in mine and they do the same thing that your describing. I would be happy to look at it and see if any of the boards I have will fit it.

[sickpony]

definitely, just pm me some info on how to contact you or whatever. Not in any big rush but I would like to get this thing going so i can play.

[sickpony]

nevermind, i see the link duh....... i will contact you

[Blackout]

It sounds like the high frequency board is bad. I had few go out in mine and they do the same thing that your describing. I would be happy to look at it and see if any of the boards I have will fit it.

what voltage are your tigs ran on. i need something that will weld up a motorcycle frame. probably a 16G round tube.

[DFWtechie]

The tigs are 220V and same with the plasmas but we are out of stock on the plasmas right now.

[dcs13]

Do you have the consumables for the Matco plasma ?

[DFWtechie]

Do you have the consumables for the Matco plasma ?

I would need to know what kind of torch you have we have about 10 diferent kinds in stock for both High Frequency torches and Pilot arc torches. I have not got the website updated with all the consumables