"Jet" brand machinery quality? bandsaw people inside

[the spindoctor]

looking to replace our old kbc 10" bandsaw at work which is on it's last leg. i see the jets advertized everywhere at decent prices, but haven't actually seen their stuff in person. we don't do anything fancy, just a few dozen straight cuts a day of tubing and solid round. is there much of a problem being a single phase motor as far as overheating or anything? our current one is 2hp 3ph and does fine.

this is what i'm looking at:

http://www.amazon.com/HSB-1018W-230-Volt-10-Inch-18-Inch-Horizontal/dp/B000GANKXS/ref=sr_1_39?ie=UTF8&qid=1310507896&sr=8-39

[Sgt Beavis]

Go look at Grizzly. They usually have lower prices but the same quality.

Also a lot of Jet's tools are made in the same Taiwanese factory that Grizzly uses.

edit: And Grizzly's customer services is known to be better.

[J&T's 82]

They are the same design as Delta. However I am not sure if the motors are the same.