Tweet
I am really thinking about doing this. Cheap Mossy 500 and a little $40 kit, $25 grip and hacksaw work.
Link to product: (endcap for magazine tube and barrel clamp)
Raptor grip:
Instructions:
The precision-machined Raptor Lug solves the problem of purchasing an expensive Mossberg 500 PGO 12-gauge firearm and then having to turn around and purchase a sometimes-even-more expensive 14″ front end kit—just to build a badass non-NFA firearm to protect you and yours.
The simplicity of building a non-NFA 14″ Mossberg 500 with the Raptor Lug is sheer genius:
Install the Raptor Grip M500 (sold separately)
Chop your barrel and magazine tube (using a hacksaw is just fine—the Raptor Lug hides the cut end)
Cut your magazine spring
Drive the Raptor Lug M500 onto your barrel and magazine tube
Drill a 1/8 hole and secure the lug in place with the included roll pin
No special tools needed. An overall length of 26.5″ is maintained throughout the process.
NOTE: The Raptor Lug fits standard Mossberg 500 and Maverick 88 12-gauge barrels. It DOES NOT fit any heavy barrels or thick-walled barrels.
The simplicity of building a non-NFA 14″ Mossberg 500 with the Raptor Lug is sheer genius:
Install the Raptor Grip M500 (sold separately)
Chop your barrel and magazine tube (using a hacksaw is just fine—the Raptor Lug hides the cut end)
Cut your magazine spring
Drive the Raptor Lug M500 onto your barrel and magazine tube
Drill a 1/8 hole and secure the lug in place with the included roll pin
No special tools needed. An overall length of 26.5″ is maintained throughout the process.
NOTE: The Raptor Lug fits standard Mossberg 500 and Maverick 88 12-gauge barrels. It DOES NOT fit any heavy barrels or thick-walled barrels.
Raptor grip:
Instructions:
Comment