So I bought a new shotgun

[LS1Goat]

Nice!

[71chevellejohn]

The only issue I've had was a few Fail to Ejects using Winchester AA Light load 2+3/4". The gas setting was on 1(probably should have been on 2). Everything else I've thrown at it has cycled fine. Over the past few weeks, I've probably already sent 250-300 shells through it.

I picked up 2 pro mag 10-round mags - If you get any of the Pro Mag magazines be sure to test fit them before shooting. Both of mine needed a little modification to make sure they fully CLICK into place.

[kingjason]

Jason I want to shoot that thing.

Next time I take it out there I will call you.

John I get all my stuff from this place except my Ammo which comes from SGAmmo in OK. I have two SGM 10 round mags and they rock and roll right out of the bag. I do want a 20 round though just for the hell of it. I am going to pull the bolt out and polish it myself I think and reprofile my new hammer a tad bit just to smooth it up a little and then I think it will be perfect (still may farm this out). I have no interest in running bulk pack like them guys over on the Saiga site but since my department carries low recoil stuff I would like it to shoot that just fine. Oh and I want the HK sights.

http://store.carolinashooterssupply.com/servlet/-strse-MAGAZINES-dsh-DRUMS-cln-SAIGA-12/Categories

[71chevellejohn]

Yeah, I should have known better from a previous Pro-Mag experience with my Riuger.

On the S12 mags, when they mold the outer case, one of the ridges comes up just a hair too much. It is easily sanded off. I picked them up on impulse at a gun show.

I've talked to a few people about the 20 round drum. They all said it affected their forward hand placement because it sticks out so far. I'm on the fence about whether or not I want one.