Announcement

Collapse
No announcement yet.

Forza challenge. Iberian circuit. A600

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #91
    Originally posted by Downs View Post
    can you be part of more than one club at a time?
    No

    Comment


    • #92
      Snatch, did u get the pass yet? We need to do some pinto drags rwd and maybe some station wagon when it comes out to

      Comment


      • #93
        Not yet. I might breakdown and purchase it shortly, though.
        I'm a bit of a tight wad.

        Comment


        • #94
          Originally posted by Snatch Napkin View Post
          Not yet. I might breakdown and purchase it shortly, though.
          I'm a bit of a tight wad.
          Its for a good cause lol

          Comment


          • #95
            I'm talking myself into it.

            I'm getting on now to see if I can break into the 10's with the Cobra.

            Comment


            • #96
              Yall using all motor or boosted? All motor seemed better for me.
              GOPR0198 by larrychance88

              Comment


              • #97
                Originally posted by BttleFedC10 View Post
                Yall using all motor or boosted? All motor seemed better for me.
                Tried both, they did about the same.

                Comment


                • #98
                  I've only run boosted thus far. I might build a N/A one next. I managed to match Deddreckoning's time last night.

                  He comes out of the hole a little better than I do (bumper to 1/2 fender) until the 1-2 shift where jumps out a car length or more. However, I run him down hard on the big end.

                  My car is heavier than his, but I've got a lot more power than him.

                  Comment


                  • #99
                    Snatch, I couldnt get better than a .083 with your tune. Damn launch, I cant get it perfect.

                    Comment


                    • how do you know how much my car be weighing snatch lol
                      2004 Mustang GT: BBK shorty headers, BBK O/R X, Flowmaster catback, JLT cold air, Trickflow 75mm TB and Plenum, UD pulleys, upper and lower CA's, 3.73, SCT XCal 2 ---- SOLD

                      Comment


                      • Originally posted by DeddRekoning View Post
                        how do you know how much my car be weighing snatch lol

                        ....educated guess from how hard I'm pulling you on the big end...

                        Comment


                        • Originally posted by musclestang89 View Post
                          Snatch, I couldnt get better than a .083 with your tune. Damn launch, I cant get it perfect.
                          It's tough. I should have played with my 2nd gear more. If I could hang with his ghost when we shift 2nd, then I know it will run a 10.99.

                          Have you raced his ghost? Do you see the same thing happening going into 2nd?

                          Comment


                          • Originally posted by DeddRekoning View Post
                            how do you know how much my car be weighing snatch lol
                            I told him lol.

                            I tuned a car last night and first pass was a .067 . Yall might should try it out to see if yall can go faster.

                            I tuned it using the benchmark lol

                            Comment


                            • I'll never trust that benchmark again after it told me my Rabbit would require 15 seconds to go from 0-100 mph, yet it would hit 138 in the 1/4 in 12.5 seconds.

                              Hell that final car I put together last night ran a .020 right out of the box, but the benchmark said it was slower than a previous car that wouldn't do any better than a VERY consistent .167.

                              Comment


                              • my car has no weight reduction just fyi...you can't be that much heavier than me
                                2004 Mustang GT: BBK shorty headers, BBK O/R X, Flowmaster catback, JLT cold air, Trickflow 75mm TB and Plenum, UD pulleys, upper and lower CA's, 3.73, SCT XCal 2 ---- SOLD

                                Comment

                                Working...
                                X