Opened up a present today from Mr Dan Davinci...
![](http://i269.photobucket.com/albums/jj77/carlrenee1/IMAG4103_zpsbpoyj2sz.jpg)
![](http://i269.photobucket.com/albums/jj77/carlrenee1/IMAG4104_zps0fjagg5i.jpg)
![](http://i269.photobucket.com/albums/jj77/carlrenee1/IMAG4105_zpsijpoybls.jpg)
Been working with Dan for a couple years now on my carb. I just never seem to get the time to get it over to him to play with it. Well I finally did and he found a few issues that were causing the part throttle stumble. One of the metering blocks had a defect in it, so he replaced both blocks. Then he installed the annular boosters, re-dyed the carb, and polished all the venture and blades. Looks like new again. Best part, did it all under warranty for me from the initial work I had him do.
If you need a carb done, go see Davinci. He is in Texas and just as good as any mail order carb you can get.
![](http://i269.photobucket.com/albums/jj77/carlrenee1/IMAG4103_zpsbpoyj2sz.jpg)
![](http://i269.photobucket.com/albums/jj77/carlrenee1/IMAG4104_zps0fjagg5i.jpg)
![](http://i269.photobucket.com/albums/jj77/carlrenee1/IMAG4105_zpsijpoybls.jpg)
Been working with Dan for a couple years now on my carb. I just never seem to get the time to get it over to him to play with it. Well I finally did and he found a few issues that were causing the part throttle stumble. One of the metering blocks had a defect in it, so he replaced both blocks. Then he installed the annular boosters, re-dyed the carb, and polished all the venture and blades. Looks like new again. Best part, did it all under warranty for me from the initial work I had him do.
If you need a carb done, go see Davinci. He is in Texas and just as good as any mail order carb you can get.
Comment