And it begins...2003 S-10 transformation

[MattB]

I think I have some sawblade wheels and some C5 wagon wheels. They have used-up auto-x/roadrace tires on them, but pm me your email addy and I'll take some pics and cut you a deal if you are interested.

[black2002ls]

I think I have some sawblade wheels and some C5 wagon wheels. They have used-up auto-x/roadrace tires on them, but pm me your email addy and I'll take some pics and cut you a deal if you are interested.

Message sent

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2

[MattB]

Give me a day or two and I'll dig them out and take some pics. I'm honestly not 100% sure exactly what I have, but you'll have the first crack at them.

[greenbullitt]

If matt doesn't, I have a set of sawblades too

[shumpertdavid]

The sawblades give it a Cyclone look in my opinion. Kind of a new edge version. I dig em.

[black2002ls]

I think you guys have me talked into them. Hopefully by the end of October the suspension is done.

Anyone happen to have some adapters laying around! lol. I can get away with no adapters in the rear by going to a 4wd rear axle. Or finding an explorer 8.8 to replace it with. The benefit to either of those is that I can get them with disc brakes. 8.8 will be beneficial when the lsjuan goes in for strength

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2

[Ratt]

Yeah, if I were you I would try to source an 8.8

[BlackGT]

So is this "project psyclone"?

[black2002ls]

So is this "project psyclone"?

No. My intentions are a factory style v8 truck. I want ot to look factory made. GM in dash navigation, factory option wheels, leather seats, LSx, etc. The rearend is an exception. As well as a few other components not normally visible

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2

[shumpertdavid]

my buddy has an explorer 8.8 sitting here at work, it would be cheap, but it will need a clutch set in the diff and i'd recommend refreshing it while it's down. PM if interested, it's in Whitesboro, TX

[black2002ls]

my buddy has an explorer 8.8 sitting here at work, it would be cheap, but it will need a clutch set in the diff and i'd recommend refreshing it while it's down. PM if interested, it's in Whitesboro, TX

Pm sent. Is it a disc brake rear?

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2

[Chas_svo]

Sawblades.

[black2002ls]

Sawblades it is. Hopefully one of the board members shoots me a killer price.

Does anyone have any insight on figuring correct wheel adapter width? I can swap the rear end and it is a non issue, however, I don't figure I can get that done for less than $250, adapters are ~$80/pr.

Surely there is a formula that figures in track width, wheel width, and backspacing....

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2

[Z06killinsbf]

Formula? Ya, jack up truck and remove factory wheel, place vette wheel in place to desired location with truck lowered to ride height, measure into hub, done.

[black2002ls]

Formula? Ya, jack up truck and remove factory wheel, place vette wheel in place to desired location with truck lowered to ride height, measure into hub, done.

Lol. I like less work same results. However, that is exactly what I will end up doing

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2