Pictures of your work?

[tribaltalon]

Man those smittybilt armor fenders are getting so overdone on JK's these days.

[Mysticcobrakilla]

Just finished this POS!

[Strychnine]

just finished this pos!

3508?

[Mysticcobrakilla]

3508?

Yes sir!

[diablo rojo]

[HarrisonTX]

This is my first PLC job since school.
It's for a heat treating and coating process of a plunger for frac pumps.
The part is heated to 400F, coated, and then heated to 1400F. Originally a guy stood there holding two torches while the the part turned on the lathe. It was hot work for the guy. The maintenance men mounted these limit switches and I did the rest.

A torch now is mounted to that square piece of steel and upon selecting "run" the torch will leave the first limit switch and bounce back and fourth between the 2nd and 3rd limit switch until the desired heat is achieved. Initially it sounded pretty simple but for a bit complicated faily quickly.
I added a DC controller and a pot to control the speed of the torch.
I built in a couple safties too. For example, the lathe cannot drop the part with it's running, yada yada yada.
Pretty rewarding adventure when all was said and done.
[the incoming wires are temped in]

[Andy@PrimeTuning]

I see you are at SPM

I hope you design works great and they send you around to all locations building one.

[HarrisonTX]

I see you are at SPM

I hope you design works great and they send you around to all locations building one.

I work for a contractor. We've been out there for three years now almost daily.
They only have three of these. 2 here and one in Houston. I may be retrofitting the other two, but that's it.

[Andy@PrimeTuning]

Tried to send a PM - Box is Full

[HarrisonTX]

I made room for you, come on in.

[Sgt Beavis]

How about my workplace from Ye Olden Tymes...

Some shots from Camp Zama Japan..









Flying over Virginia


My crew of misfits..


Promotion to Sgt


Running around the Munchkin Land Military Ball.. Seriously damn midgets everywhere in this unit..

[turboford]

Pictures of your work?

Damn I can't get the pic to load right.

[HarrisonTX]

Killer huey pics man. I never got to ride in one. Countless blackhawk and chinhook missions but I only even saw a huey in flight once.

[inline 6]

Speaking of huey.... When I was in San fran last month working this was in the same hangar.







And so were these.....

[Sgt Beavis]

Killer huey pics man. I never got to ride in one. Countless blackhawk and chinhook missions but I only even saw a huey in flight once.

Yea, Desert Storm was the last time they saw any significant action.