Post your Garage

[GrayStangGT]

Back before I sold the camaro

[red95gts]

[01yz2nv]

How are those cabinets holding up? I was looking at getting some of those.

[red95gts]

Good...I like them a lot but they are really expensive if you pay full retail price. If you are looking, keep a close eye on slickdeals.net - you can even set up email alerts to trigger on the word "Gladiator." Every few months, Sears will blow these things out and the people on SlickDeals will figure out how to combine coupon codes, etc, etc in order to get the best deals.

I've got several cabinets and tons of wall paneling, hooks, etc and the most I've paid is 50% of regular price. The 30" wall cabinets are typically $200-$225ea and I picked three of them up for $99ea... The 48" wall mount pieces are usually $11 at Lowes. Got 6 of them at Sears for $28.50...

I'm still looking for the fold-down work surface/desk piece, but won't pay $240 for it. Sears had it for $107 and I should have pulled the trigger, but decided to wait it out. That was 9 mos ago and haven't seen it that cheap since.. lol

[KBScobravert]

Here is my 3 car 26' deep garage. All the walls are filled with insulation, the ceiling has a layer of r13 and the doors are sheeted with 1.25" of foam. All that was done to keep the heat/cool inside that the 2 ton split unit air conditioner provides. For lights I am using 13 4' dual bulb light sets.








All 4"x4" with 3/4" mdf top with another 1/8" fiberboard sheet on top of that. I am thinking of getting rid of it and doing another that is purpose built to fit the lower Craftsman boxes.

[Rreemo]

Mine is 28' deep, and that has been one of the things I've liked the most...plenty of room on both ends of the car with the doors down. However my limiting factor is height...not enough for a lift....that's why I'm about to break ground on a 40x50 shop. We'll turn the garage back into parking space, move the projects and all of my equipment out to the shop.

[KBScobravert]

Mine is 28' deep, and that has been one of the things I've liked the most...plenty of room on both ends of the car with the doors down. However my limiting factor is height...not enough for a lift....that's why I'm about to break ground on a 40x50 shop. We'll turn the garage back into parking space, move the projects and all of my equipment out to the shop.

20' is for suckers. I almost vaulted my ceiling to accept a lift but the wife stepped in. Maybe if I ever build that mother-in-law suite I will get my shop on the front of it.

[Blackout]

[Baba Ganoush]

So OP, tell us about your floor. That is a sharp setup you have!

I need more ceiling, and a lift......and a better picture.
30X30

[Grape]

the clean side



the dirty side for all the fab work


dyno room for the engine junk

[95ragtop]

^Nice!

[dville_gt]

[Ratt]

^ One of these things is not like the other!

[Blackpony]

Little messy right now but..

[Junkie]