New Turbo kit I'm building

[turbostang]

Flux core welder getting it done

where?

[Dan03mach]

Ok. I'm 99% sure I have it, I have to get up in the attic to check. I'll PM you my number, you can call later if you want to come get it

Cool deal thanks Brooks

[Dan03mach]

Flux core welder getting it done

It's a Mig...

[dville_gt]

good job dan. think that w/b sensor is going to have any problems being that close to the turbine housing?

[4EyedTurd]

The coloring around the welds makes me think he isn't using gas but I was wrong

[suckerdin]

jesus fuck that thing is ginormous.

[Dan03mach]

good job dan. think that w/b sensor is going to have any problems being that close to the turbine housing?

I doubt it, same location that my other sensor was located at.

[dville_gt]

I doubt it, same location that my other sensor was located at.

I just remember the guys at innovate saying 12in minimum from the flange. Probably just watching their butts for warranty issues (not that they'll ever cover a sensor anyway though )

[FRANCISCO308]

Yeah I'm going to put a screen in front of the inlet. It is a Garrett GT4276. I can't really fit a larger DP where I have this one going thru the K-member right now. It is a 3.5" DP...

What kinda screen are you gonna put? Looks good!

[turbostang]

I had a bunch of problems on my car with the 02 sensor mounted 18" from the turbine. I burned up a few of them, finally - after doing some reading, they offer a copper heat sink to stop this. I just used an aluminum disc from a hole saw cut out..drilled out the center hole to pass the 02 threads through..never had another problem.

[shumpertdavid]

I just remember the guys at innovate saying 12in minimum from the flange. Probably just watching their butts for warranty issues (not that they'll ever cover a sensor anyway though )

My innovate kit uses a bosch sensor that is $49 (my cost through Oreilly's) and has a lifetime warranty. I've had to replace mine several times due to tuning issues (no cost to me)

[5.0 n it]

Looks good dirty d

[Hell-Bent SS]

Next time you have some welds to do hit me up and I can tig weld them for you if you want me too.

[XR_1]

Looks good but the 02 sensor looks to close to the turbo
I would have put it 6-10" away but it should work

[Dan03mach]

Next time you have some welds to do hit me up and I can tig weld them for you if you want me too.

Thanks man I just wanted to build everything my self. I know a Mig isn't the best welder to use on a turbo kit I have a Tig at work I could use I'm just not good at using it. I'm still learning...