Need help with plumbing on a shower install

[03mustangdude]

Doing a tub/shower to just a shower conversion slowly but surely. Getting ready to hang the hardibacker board and do the plumbing.

I bought a shower panel that only needs a 1/2" line screw on fitting for the hot and cold side and it attaches on the bottom.

All the valves etc and plumbed on.

Reading the different installs online you can just attach a valve and then attach the hoses from the shower panel.

Can I just cut the copper line and install a sharkbite followed by a 1/2 valve or is it a better way to do it without welding ( no clue how to weld)

Here is a pic.

[8mpg]

just sweat a new one on. Its easy to do. Watch youtube on how to sweat copper pipe

[jakesford]

just sweat a new one on. Its easy to do. Watch youtube on how to sweat copper pipe

This, its super easy to do...

[03mustangdude]

So just cut the pipes where shown and sweat a valve on each side and then a threaded piece onto it right?